I_o-magic MagicSpin Manuel d'utilisateur télécharger pdf (Page 12)

MagicSpin Installation Guide

Page 12

4 Connect the IDE interface cable.

Connect the 40 pin IDE cable into the MagicSpin CD-ROM drive’s IDE connector

located on the back of the CD-ROM drive (Figure 5).

Make sure to align the red-lined edge of cable with Pin-1 of the IDE connector. Connect

the other end into either your motherboard IDE controller, or your IDE controller card

plugged into your motherboard (Figure 6).

5 Connect the Audio cable from your Sound Card (If necessary).

If you have a sound card or an audio interface card, use the audio cable to connect from

the sound card audio port (SONY or IDE) to the MagicSpin CD-ROM drive’s Analog

Audio connector located on the back panel (Figure 4).

6 Re-attach the computer’s cover.

Figure 6: IDE connection

Figure 7: Connection to Motherboard

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Pas de commentaire

I_o-magic MagicSpin Manuel d'utilisateur Page 12